They put three screws through each overlapping section from the leg extension to the original leg. It is also cut out in an L-shape for the length of the leg to create a sturdier join than just attaching at the end. It was a couple of years ago now that my father-in-law and husband customized this table, so I’m not sure exactly of the hardware that they used.Įach leg is supported with a chunk of 2 x 3″ wood (actually 1.5 x 2.5″) that is 7.5 inches tall. But it is strong, sturdy, and functional, which is everything I need it to be. The materials and method used to raise the height and attach castors to the bottom of the legs may not be the most elegant solution. In addition, we needed to create a wider surface than the width of the legs to be able to attach the plate of the castors. Raising the IKEA Norden Into A DIY Cutting TableĪdding height to the legs of the IKEA Norden table is challenging because the legs of the two gate-legs are much narrower than the four legs under the centre of the table. I knew he and my husband could figure it out together. Then I sent all the example links to my father-in-law in advance of their upcoming trip to visit us. We kept an eye on the Norden table on the IKEA website for a while, and in a stroke of luck, it went on a sale with the IKEA family membership. One had castors added to it so it was moveable. In the other hacks I saw, the legs were raised to bring it to counter height. Best of all, when both ends are down, it is just 12.75″ long – super skinny! When just one end is up, it is 36.5″ long. It is 31.5″ wide, and when it is opened fully with both ends up, it’s 60″ long. Without changes, the Norden table is 29″ tall. It also has drawer storage on the ends, and comes in white, or birch. The beauty of the Norden table is that it is a gate-leg table that can have both ends up, just one, or none. Then I stumbled on a few versions of the IKEA Norden dining table that had been adapted into a cutting table. I’d love to have the space and permanence of something like that some day, but it wouldn’t work for my current needs. This produced a table with similar depth and heft of a cutting table at a fabric shop. I found a lot of brilliant ones on top of two dressers placed back to the back. I did a lot of scouting around on the Internet for DIY cutting table ideas, particularly ones that were flexible and could partially fold up. Therefore, I didn’t have room for a really large cutting table to be out all the time. And although the room was a good size, it also doubled as a spare bedroom. So I needed to find a solution that was better for my back and that would stay in my sewing room. Plus, I had to transport everything back and forth to my sewing room. But it also meant I had to clear it to work on, and clear it off again for meal times. But cutting with my mat on the floor was dreadful for both my knees AND my back.Ĭutting fabric on the kitchen counter was the most ergonomic option. Despite being just over 5 ft tall, hunching over my sewing table was hard on my back. But I found cutting fabric for quilts awkward no matter where I did it. In our next apartment, I had much more room to work with and a dedicated sewing/craft room to myself. In the first apartment, I sewed on our dining table, cut fabric on our kitchen counters, and laid out quilt blocks on the top of the bed. Since I learned to quilt, we have lived in several apartments.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |